37 lines
2.0 KiB
Plaintext
37 lines
2.0 KiB
Plaintext
# specifies the time (in seconds) to wait for response to a prompt by auth_x11 before giving up and
|
|
# reverting to the screen saver.
|
|
XSECURELOCK_AUTH_TIMEOUT=10
|
|
|
|
# specifies the time (in seconds) before telling X11 to fully blank the screen; a negative value
|
|
# disables X11 blanking. The time is measured since the closing of the auth window or xsecurelock
|
|
# startup. Setting this to 0 is rather nonsensical, as key-release events (e.g. from the keystroke
|
|
# to launch xsecurelock or from pressing escape to close the auth dialog) always wake up the screen.
|
|
XSECURELOCK_BLANK_TIMEOUT=10
|
|
|
|
# create a second full-screen window to obscure window content in case a running compositor unmaps
|
|
# its own window. Helps with some instances of bad compositor behavior (such as compositor crashes/
|
|
# restarts, but also compton has been caught at drawing notification icons above the screen locker
|
|
# when not using the GLX backend), should prevent compositors from unredirecting as it's 1 pixel
|
|
# smaller than the screen from every side, and should otherwise be harmless, so it's enabled by
|
|
# default.
|
|
XSECURELOCK_COMPOSITE_OBSCURER=1
|
|
|
|
# the date format to show. Defaults to the locale settings.
|
|
XSECURELOCK_DATETIME_FORMAT=%F %T
|
|
|
|
# time_ shows the current time since the epoch on each keystroke. This may be the most secure mode,
|
|
# as it gives feedback to keystroke based exclusively on public information, and does not carry
|
|
# over any state between keystrokes whatsoever - not even some form of randomness.
|
|
# time_hex: same as time, but in microseconds and hexadecimal. "Because we can".
|
|
XSECURELOCK_PASSWORD_PROMPT=time_hex
|
|
|
|
# whether to show local date and time on the login. Disabled by default.
|
|
XSECURELOCK_SHOW_DATETIME=1
|
|
|
|
# whether to show the hostname on the login screen of auth_x11. Possible values are 0 for not
|
|
# showing the hostname, 1 for showing the short form, and 2 for showing the long form.
|
|
XSECURELOCK_SHOW_HOSTNAME=0
|
|
|
|
# whether to show the username on the login screen of auth_x11.
|
|
XSECURELOCK_SHOW_USERNAME=0
|